Welcome. Type CLI commands below or use the dashboard buttons above.
>
- Connect to Flipper to browse files
Drop files here to upload, or click to select
Listen for Sub-GHz signals (remotes, garage doors, weather stations, doorbells).
Select a frequency and duration, then click "Listen". Uses the Flipper's built-in CC1101 radio. Press a remote or trigger a device during the listen window to capture its signal.
Select a frequency and duration, then click "Listen". Uses the Flipper's built-in CC1101 radio. Press a remote or trigger a device during the listen window to capture its signal.
Saved Signals
No saved signals yet.
Capture signals with Listen, then save them here.
Capture signals with Listen, then save them here.
Read NFC tags (13.56 MHz) or RFID cards (125 kHz).
Select the type, click "Scan", then hold the tag/card against the back of the Flipper. NFC reads badges, transit cards, NTAG stickers, Mifare, and phone NFC. RFID reads keycards, EM4100, HID ProxCards, and other 125 kHz cards.
Select the type, click "Scan", then hold the tag/card against the back of the Flipper. NFC reads badges, transit cards, NTAG stickers, Mifare, and phone NFC. RFID reads keycards, EM4100, HID ProxCards, and other 125 kHz cards.
Saved Tags
No saved tags yet.
Scan NFC/RFID tags, then save them here.
Scan NFC/RFID tags, then save them here.
WiFi scanning via Marauder (ESP32 Dev Board over UART).
Make sure your Flipper is connected above, then click "Scan APs" to find nearby networks. Scans take ~10 seconds as commands are routed through the Flipper's UART to the ESP32.
Make sure your Flipper is connected above, then click "Scan APs" to find nearby networks. Scans take ~10 seconds as commands are routed through the Flipper's UART to the ESP32.
Learn and transmit infrared signals (TV, AC, Audio remotes).
Point a remote at the Flipper's IR receiver and click "Learn" to capture signals. Use "Transmit" to replay captured signals, or use the Universal Remote buttons.
Point a remote at the Flipper's IR receiver and click "Learn" to capture signals. Use "Transmit" to replay captured signals, or use the Universal Remote buttons.
Remote
No signals yet.
Capture signals with Learn or import from IRDB.
Capture signals with Learn or import from IRDB.
Virtual D-pad — click to send short press, hold 500ms+ for long press
Click "Start Mirror" to stream the Flipper's LCD screen in real time.
The display is 128x64 pixels, auto-scaled to fit. Frame rate is typically 3-5 FPS depending on serial throughput.
The display is 128x64 pixels, auto-scaled to fit. Frame rate is typically 3-5 FPS depending on serial throughput.